A circuit and method for charging batteries while a power supply also powers a dynamically varying load. All power in excess of that required by the load is used by a power converter to charge the batteries. The circuit advantageously allows the load to change from external power to battery power without switching delays.
A method of charging a battery from a power source is provided. The method includes providing a charge circuit in series with the battery and the power source. A charging current flowing to the battery and a voltage across the charge circuit are sensed. The power dissipated in the charge circuit is computed based on the charging current and the voltage across the charge circuit. During a first operating mode, the charging current is controlled so that the power dissipated in the charge circuit is about a predetermined maximum dissipation. During a second operating mode, the charging current is limited to a predetermined current level. During a third operating mode, the charging current is controlled so that the battery voltage is about a predetermined voltage level.
A battery charger for charging a battery from a power source is provided. The battery charger includes a current sense circuit in series with the power source and the battery. A linear preregulator includes a first controlled switch coupled to the power source to generate a regulated output. The first controlled switch is responsive to a preregulator control signal, varying the first controlled switch impedance so that the regulated output is generated. A control circuit is powered by the preregulator regulated output. The control circuit generates the preregulator control signal and a charger control signal. A second controlled switch is coupled between the regulated output and the battery. The impedance of the second controlled switch is varied in response to the charger control signal so that a regulated flow of charge is supplied to the battery.
A power management topology for portable electronic devices that includes a feed-enabled AC/DC adapter that receives feedback data from a charge controller associated with the portable device. The feedback data can include battery charging current, battery voltage, or power requirements of the portable device. Using the feedback data, the external AC/DC adapter can adjust the DC output to meet the charging requirement of the battery and/or the power requirements of the portable device.
In a power factor corrector including a PWM switch to switch a line current generated from a line voltage to charge a boost capacitor to thereby generate an output voltage, a piecewise on-time modulation apparatus and method comprise comparing a line voltage dependent voltage with an output voltage dependent voltage to generate a comparison signal to determine the on-time of the PWM switch. When the line voltage is lower than a threshold, the on-time of the PWM switch varies with the line voltage, and when the line voltage is higher than the threshold, the on-time of the PWM switch is constant.
A DC-DC converter generally includes a supply circuit, a charge circuit, and a control unit connected to the charge circuit. The charge circuit receives the input current and supplying a charge current to the battery. The control unit controls the charge current according to the results of comparisons between various currents and voltages and corresponding threshold levels. The control unit, which may be constructed on a single-chip semiconductor substrate, includes a differential charge controller, a charge current controller, a charge voltage controller, and a dynamic charge controller. These elements respectively compare the input current, the charge current, the charge voltage and an input voltage from the external DC power supply with a threshold values and control the charge current and charge voltage according to a result of the comparisons.
