Power management logic maintains memory in a computer system in the self refresh state during a power savings state in which power is removed from the memory controller. A memory control circuit, separate from the power management logic, controls the memory during other operational modes. The power management logic maintains the system memory in the self refresh state by driving memory control signal(s) at appropriate values during the power savings state.
An interruption control system includes a first input/output interruption controller, a second input/output interruption controller, and an interruption control device bus. The first input/output interruption controller is coupled to a first peripheral device and a south bridge chip, and asserts a wake-up signal to the south bridge chip in response to a first interrupt signal issued by the first peripheral device so as to deactivate a power-saving state of the computer system. The second input/output interruption controller is coupled to a second peripheral device and a north bridge chip, and asserts a third interrupt signal in response to a second interrupt signal issued by the second peripheral device. Via the interruption control device bus, the third interrupt signal is transmitted from the second input/output interruption controller to the first input/output interruption controller, wherein the first input/output interruption controller asserts the wake-up signal to deactivate the power-saving state of the computer system in response to the third interrupt signal.
An interruption control system includes a PIC, an APIC and a power management unit disposed in a south bridge chip of a computer system. In response to the triggering of an interrupt status indicating signal received through an interrupt status indicating pin of a north bridge module or by the triggering of a peripheral device coupled to the south bridge chip, the PIC sends an interrupt signal to the CPU via an interrupt request signal pin when the computer system is in a PIC mode. The APIC is disabled when the computer system is in the PIC mode, and enabled when the computer system is in an APIC mode to generate a memory write cycle message to the CPU in response to the triggering of the peripheral device. The power management unit is optionally triggered with the interrupt signal or the interrupt status indicating signal to awake the CPU.
A reconfigurable memory in an integrated circuit includes an array of memory cells and a memory controller. The array of memory cells in the reconfigurable memory are tested to determine if they are unusable and if so, their associated physical addresses corresponding to their physical location. After determining the physical addresses where any failure exists, the physical addresses locations associated with the physical locations of unusable memory cells or memory blocks are mapped out to avoid addressing them. While mapping out unusable memory locations or memory blocks reduces the total capacity, the reconfigurable memory has sufficient capacity for the integrated circuit to remain functionally usable.
A reconfigurable memory in an integrated circuit includes an array of memory cells and a memory controller. The array of memory cells in the reconfigurable memory are tested to determine if they are unusable and if so, their associated physical addresses corresponding to their physical location. After determining the physical addresses where any failure exists, the physical addresses locations associated with the physical locations of unusable memory cells or memory blocks are mapped out to avoid addressing them. While mapping out unusable memory locations or memory blocks reduces the total capacity, the reconfigurable memory has sufficient capacity for the integrated circuit to remain functionally usable.
A system for implementing a memory subsystem command interface, the system including a cascaded interconnect system including one or more memory modules, a memory controller and a memory bus. The memory controller generates a data frame that includes a plurality of commands. The memory controller and the memory module are interconnected by a packetized multi-transfer interface via the memory bus and the frame is transmitted to the memory modules via the memory bus.
